For anyone else who ever has this problem, there are easier ways than a paper clip and hammer.
I have used pencil lead (0.5mm) successfully. You get a short piece and push hard, it might hurt your thumb a bit but it works. Obviously most needles work but I have used things like safety pins from the back of a shirt pin. I’ve also used the tip of mechanical pencils in a pinch. And if you’re crafty you can do something (carefully) with a toothpick and a knife to shave the tip down. Dumbest thing I’ve ever used is a disposable flosser that had a toothpick on the end. I also used that to clean USB C ports. All of these also similarly work on small reset buttons on routers and such.
I assume you just leave the keyring on your desk/in some drawer? I had handcuff keys on my normal ring and the pointy thing on the keys (for double-locking) made holes in my jeans, so you’d be crazy to go around with those for opening SIMs in your pocket.
I have a Moonlander split keyboard that is programmable and uses one of these little things for its reset button. My only gripe with it is that they could have designed a place for it to slot into the keyboard itself since it’s very easy to lose it if it isn’t otherwise attached to something.
The reset button is used to apply firmware changes. For this keyboard you can customize the keys to pretty much however you like. I have one of the thumb cluster buttons set to Ctrl-C / Ctrl-V for efficiency. It’s great for making changes to personalize your mechanical keyboard experience… but it requires that pin to make changes lol.
I like it since I can assign Enter to one of the left thumb cluster buttons, you normally can’t hit enter with your left hand on a standard keyboard layout.
How often do you use them? I now throw away almost every extra piece of anything and for the past 8 years or so I haven’t really regretted it and important stuff is easier to find without all the junk noise.
telegra.ph
Oldest