If you do WLED you should have no need for a bread board. Just get an ESP8266 with male headers and a nice(ish) 12V power supply that can run your strip. From Arduino to LED strip you only need to connect the data pin and ensure 12V PSU ground and 5V PSU ground are connected.
til, thanks!
I am leaving the hiding of wires out because I have no clue.
that part’s easy
I am curious as to what strip you are planning to use as you will need to (at least from my perspective) hack it apart and extend it with wires to get it nice.
i may not have been clear, that was the question, im not sure how to get a rgb strip with big enough gaps between the leds