The downside is the volt is not 1.5volts. Its closer to 1.2volts. This is fine if you’re using 2 batteries for things like the TV remote. But when you’re using things that require more than 4 batteries, then you might get into some weirdness. I have a remote for my DSLR that sends infrared to the softbox. Every 10 shots, it would miss the shot. It turned out to be the batteries. It needed all 6Volts vs 4.8Volts.
These days there’s also Lithium ion AA batteries, with different voltages. You can get them downvolted to anything from 1.5 to 1.8V.
The ones over 1.5V are commonly used in applications with electronic motors, since it allows you to effectively overdrive the toy or whatever it is you’re powering.
Alkaline batteries lose voltage as they drain, so 1.5V is at full charge but it drops down to about 1.2V very quickly and then stays at 1.0V - 1.2V for most of the alkaline battery’s operating life.
NiMH batteries tend to consistently stay at their nominal voltage (1.2V) through their entire charge.
So in other words, if you have devices that really expect exactly 1.5V per battery, they would only work with alkalines at the very top of their charge. Nowadays most non-garbage circuits should be designed to work just fine with anything above 1V per battery.
Every battery has a voltage curve though; even alkaline batteries will drop off the 1.5v region after some time. Comparatively, ni-mh rechargeables will hold 1.2v more consistently and for longer than an alkaline, where it's voltage drops pretty quickly as the battery dies.
Struwwelpeter is absolutely not a fairy tale though. Fairy tales can be gruesome in their own way, but nothing to do with this story - it’s by a single author.
lemmy.ml
Active